DES-HSM
Hardware security module (HSM) is a PKI CA certificate that is required by certain configuration
servers during the phone provisioning using DES. For such configuration servers, the DES is
configured with the required Avaya signed certificate by the DES administrator. When the phone
contacts the DES, the phone obtains the signed certificate from DES - HSM, and creates a secure
connection with the management configuration server.
Disabling DES
During the first boot-up, the administrator can disable the DES discovery in either of the following
ways:
• by setting DES_STAT as 0 or 1 in DHCP option 242
• by setting DES_STAT as 0 or 1 in the 46xxsettings.txt file
• by disabling DES Discovery in the phone web interface (Management > Device Enrollment
Service > DES Discovery)
Phone installation without DES
This section describes the procedure to install the phone without invoking the DES discovery
process.
Hardware and software prerequisites
Check the prerequisites to ensure that you have the required software and hardware before you
install the Avaya J100 Series IP Phones .
Hardware prerequisites
Ensure that the LAN:
• Uses Ethernet Cat. 5e or Cat. 6 cabling
• Has either of the following specifications:
- 802.3af PoE
- 802.3af PoE injector
Note:
You can also power the phone using the Avaya DC 5 volt AC power adapter which can be ordered
with the device.
Software prerequisites
Ensure that your network already has the following components installed and configured:
• Avaya Aura
®
Session Manager 6.3.8 or later
• Avaya Aura
®
Communication Manager 6.3.6 or later
• Avaya Aura
®
System Manager 6.3.8 or later
Phone installation process
July 2019 Installing and Administering Avaya J100 Series IP Phones 29
Comments on this document? infodev@avaya.com
To Next Page
Loading...
