Avaya J129 - PHONEKEY Parameter Values

Parameter Name Default Value Description
WLAN_DSCPAUD
46
Specifies the layer 3
Differentiated Services (DiffServ)
Code Point for audio frames
generated by the telephone.
Valid value is from 0 to 63.
WLAN_L2QSIG
3
Specifies the layer 3
Differentiated Services (DiffServ)
Code Point for audio frames
generated by the telephone.
Valid value is from 0 to 63.
SET WLAN_DSCPSIG
34
Specifies the layer 3
Differentiated Services (DiffServ)
Code Point for signaling frames
generated by the telephone.
Valid value is from 0 to 63.
PHONEKEY parameter values
This section contains the full list of PHONEKEY parameter values and their definition.
The common syntax for the PHONEKEY parameter is the following:
SET PHONEKEY "Key=1;Type=feature;Name=autocallback;forced"
where
Type and Name can take other values. For the full list of allowed values, refer to the table below.
For additional settings of the PHONEKEY parameter and the details on its syntax, refer to the
Additional parameters column.
PHONEKEY
setting
Allowed values Definition Additional parameters
Feature
(Type=featu
re)
autocallback Automatic Call Back
prioritycall Priority Call
whisperpage Whisper Paging
callpark Call Park
callunpark Call Unpark
callpickup Call Pickup
callpickupext Call Pickup
Extended
callpickupdir Call Pickup Directed
Table continues…
PHONEKEY parameter values
July 2019 Installing and Administering Avaya J100 Series IP Phones 323
Comments on this document? infodev@avaya.com