System parameter
name
TLV name Impact
L2Q, L2QVLAN TIA LLDP MED
Network Policy
(Voice Signaling)
L2Q - set to 2 (off) if T (the Tagged Flag) is set to 0 and to 1
(on) if T is set to 1.
L2QVLAN - Set to the VLAN ID in the TLV.
L2QAUD - Set to the Layer 2 Priority value in the TLV.
DSCPAUD - Set to the DSCP value in the TLV.
A check is made as to whether a reset is necessary to obtain a
new IP address due to a change in the values of the
parameters L2Q or L2QVLAN.
This TLV is ignored if:
• The value of USE_DHCP is 0 and the value of IPADD is not
0.0.0.0.
• The Application Type is not 1 (Voice) or 2 (Voice Signaling).
• The Unknown Policy Flag (U) is set to 1.
SIP_CONTROLL
ER_LIST
Proprietary Call
Server TLV
SIP_CONTROLLER_LIST will be set to the IP addresses in
this TLV value.
Note:
This parameter cannot be used in an environment where
both SIP phones and H.323 phones exist.
TLSSRVR and
HTTPSRVR
Proprietary File
Server TLV
L2Q Proprietary 802.1 Q
Framing
If the value of TLV = 1, L2Q is set to 1 (On).
If the value of TLV = 2, L2Q is set to 2 (Off).
If the value of TLV = 3, L2Q is set to 0 (Auto).
A check is made as to whether a reset is necessary to obtain a
new IP address due to a change in the values of the
parameters L2Q or L2QVLAN.
This TLV is ignored if:
• The value of USE_DHCP is 0 and the value of IPADD is not
0.0.0.0.
• The current L2QVLAN value was set by an IEEE 802.1
VLAN name.
• The current L2QVLAN value was set by a TIA LLDP MED
Network Policy (Voice) TLV.
Configuration through LLDP
July 2019 Installing and Administering Avaya J100 Series IP Phones 47
Comments on this document? infodev@avaya.com
To Next Page
Loading...
