VLAN support on the computer or PC port
In full VLAN separation mode, the phone only supports one VLAN on the computer port. In no
VLAN separation mode, all VLANs pass between the LAN and PC ports. However, the CPU port
receives all traffic even on VLANs that are not equal to L2QVLAN.
Related links
Virtual LAN (VLAN) on page 54
VLAN parameters
The following configuration parameters are used to configure VLAN functionality on the network
switch internal to the phone.
Parameter name Default value Description
L2Q 0 Specifies the VLAN tagging is enabled or
disabled.
Value operation:
• 0: Auto. VLAN tagging is turned on when the
network can support VLAN tagging and
L2QVLAN is non zero.
• 1: On. VLAN tagging is turned on when the
network can support VLAN tagging. The IP
phone sends tagged frames with VLAN =
L2QVLAN, even if L2QVLAN is set to 0.
• 2: Off. VLAN functionality is disabled.
L2Q is configured through:
• Local admin procedure
• A name equal to value pair in DHCPACK
message
• SET command in the Settings file
• DHCP option 43
• LLDP
Table continues…
Servers, VLAN, and IP configuration
July 2019 Installing and Administering Avaya J100 Series IP Phones 58
Comments on this document? infodev@avaya.com
To Next Page
Loading...
