Note:
Do not use DHCPv6 and SLAAC simultaneously for same subnet.
Avaya J100 Series IP Phones can have multiple IPv6 addresses, all of which can be SLAAC.
For more information about configuring parameters for assigning an IPv6 address, see IPv6
configuration on page 63.
Configuring IPv4 from the phone menu
About this task
Use this procedure to configure DCHPv4 from the phone Ethernet IPv4 menu. In this menu, you
can also view the phone IPv4 address, gateway and mask IPv4 adresses.
Note:
If you disable Use DHCP option, manual input mode will be enabled.
Before you begin
Obtain the access code to Administration menu.
Procedure
1. On the phone, press Main Menu.
2. Scroll to Administration, and press Select.
3. In the Access code field, enter the administration password.
The default access code is 27238.
4. Press Enter.
5. Scroll to IP Configuration, and press Select.
6. Scroll to Ethernet IPv4, and press Select.
7. Scroll to Use DHCP, and press Toggle to enable or disable DCHPv4.
8. Press one of the following:
• Save
• OK
9. (Optional) Press Cancel to exit the menu without saving the changes.
Configuring IPv4 from the web interface
Before you begin
Obtain the access code to Administration menu.
Servers, VLAN, and IP configuration
July 2019 Installing and Administering Avaya J100 Series IP Phones 62
Comments on this document? infodev@avaya.com
To Next Page
Loading...
