On the phone, use Administration menu for the following:
• Enable the web server.
• Get the IP address of the phone.
See
Enabling access to the web interface through the Phone Administration menu on page 93
and Viewing IP address of the phone on page 94 for more details.
Procedure
1. In your browser, enter the IP address of the phone, and press Enter.
2. On the Login page, enter the username and the password in the corresponding fields.
For more information about changing the default password, see Logging in and logging out
of the web interface on page 95.
3. Navigate to Ethernet > IPv4 Configuration.
4. Configure IPv4 addresses in the following way:
• To enable DHCPv4, select Yes from the drop-down menu next to the Use DHCP option.
• Enter the required values in IPv4 Address, Subnet Mask and IPv4 Gateway fields.
5. Scroll to the end of the Ethernet page, and press Save.
IPv6 configuration
Use the 46xxsettings.txt file to set the following parameters for IPv6 operation:
Parameter name
Default value Description
DHCPSTDV6 0 Specifies whether DHCPv6 will
comply with the IETF RFC 8415
standard and immediately stop
using an IPv6 address if the
address valid lifetime expires, or
whether it will enter an extended
rebinding state.
Value operation:
• 0: DHCPv6 enters proprietary
extended rebinding state
(continue to use IPv6 address,
if DHCPv6 lease expires).
• 1: DHCPv6 complies with IETF
RFC 8415 standard
(immediately release IPv6
address, if DHCPv6 lease
expires).
Table continues…
IPv4 and IPv6
July 2019 Installing and Administering Avaya J100 Series IP Phones 63
Comments on this document? infodev@avaya.com
To Next Page
Loading...
