Avaya J129 - Chapter 10: Holding Calls

Configuring IPv6 from the phone menu
About this task
Use this procedure to configure IPv6 addresses from the phone Ethernet IPv6 menu. In this menu,
you can also view the phone IPv6 address, gateway address and prefixes if configured.
Note:
If you disable Use DHCP option, manual input mode will be enabled after rebooting the
phone.
Before you begin
Obtain the access code to Administration menu.
Procedure
1. On the phone, press Main Menu.
2. Scroll to Administration, and press Select.
3. In the Access code field, enter the administration password.
The default access code is 27238.
4. Press Enter.
5. Scroll to IP Configuration, and press Select.
6. Scroll to Ethernet IPv6, and press Select.
7. Do one of the following:
• Configure as required Use DHCP(V6) or Use SLAAC fields by pressing Toggle.
• Enter IPv6 addresses manually in Phone(v6) and Gateway(v6) fields.
8. Press one of the following:
• Save
• OK
9. (Optional) Press Cancel to exit the menu without saving the changes.
Configuring IPv6 from the web interface
Before you begin
Obtain the access code to Administration menu.
On the phone, use Administration menu for the following:
• Enable the web server.
• Get the IP address of the phone.
IPv4 and IPv6
July 2019 Installing and Administering Avaya J100 Series IP Phones 65
Comments on this document? infodev@avaya.com