• View
• 802.1X
• Signaling
• Web server
Note:
When changed, some of the parameters require the phone reboot after exiting the
Administration menu or immediate reboot. You will get the notification when configuring the
parameters which need the phone reboot.
Related links
Phone configuration on page 74
Accessing the Admin menu after log in on page 77
Using the debug mode on page 79
Setting the Ethernet interface control on page 80
Group identifier on page 81
Setting event logging on page 81
Administering enhanced local dialing on page 82
Restarting the phone on page 84
Configuring Wi-Fi using phone UI on page 85
Configuring SIP settings on page 85
Setting Site Specific Option Number (SSON) on page 87
Setting the 802.1x operational mode on page 88
Resetting system values on page 89
Accessing the Admin menu during phone startup
Before you begin
Ensure you set the following parameters in the Settings file:
• PROCSTAT: To administer the phone using admin menu, set the parameter to zero.
• PROCPSWD or ADMIN_PASSWORD: The default password is 27238. You must change the
default password at the time of initial installation.
Procedure
1. Press Main Menu softkey.
2. On the Access code screen, enter the admin menu password using the dialpad.
3. Press Enter.
Phone configuration
July 2019 Installing and Administering Avaya J100 Series IP Phones 75
Comments on this document? infodev@avaya.com
To Next Page
Loading...
