Avaya J129 - Configuring SIP Settings; Configuring Wi-Fi Using Phone UI

Configuring Wi-Fi using phone UI
About this task
Use this procedure to configure a Wi-Fi network by using phone UI. Note that switching networks
causes a reboot of the phone.
Procedure
1. Navigate to Main Menu > Administration.
2. In the Access code field, enter the administration password.
The default access code is 27238.
3. Press Enter.
4. Select Network Interfaces.
5. Use the right arrow key to change Network mode to Wi-Fi.
6. Configure the following parameters:
• Network config: Specifies if the WLAN is connected automatically or manually.
• SSID: Specifies the network name for the WLAN you are using. Use the navigation key
to select another SSID.
• Wi-Fi networks: Displays available WLAN.
7. Use the navigation key to select a WLAN, and press Connect.
8. Press one of the following:
• Save
• Cancel
• Change
Related links
Configuring the phone using Administration menu on page 74
Configuring SIP settings
About this task
Use this procedure to set up SIP-related settings, such as identifying the SIP proxy server.
Note:
In IP Office the autogenerated J100 settings.txt includes the settings for the SIP servers
and protocols. The settings are based on the SIP values set in the IP Office system
configuration.
Procedure
1. Press Main Menu > Admin.
2. In the Access code field, enter the admin menu password.
Phone configuration
July 2019 Installing and Administering Avaya J100 Series IP Phones 85
Comments on this document? infodev@avaya.com