The phone displays the following settings:
• Supplicant
• Pass-thru mode
5. Select the setting that you want to change.
6. Press the Change softkey or the Left and Right Arrow keys to cycle through the following
settings:
• For the Pass-thru mode:
- On: If DOT1X = 0
- On & proxy logoff: If DOT1X = 1
- Off: If DOT1X = 2
• For the Supplicant:
- Disabled: If DOT1XSTAT = 0
- Unicast: If DOT1XSTAT = 1
- Multicast: If DOT1XSTAT = 2
7. Press Save.
When you change the 802.1X data, the phone restarts after you exit the administration
menu.
Setting the 802.1x operational mode
December 2018 Installing and Administering Avaya J100 Series IP Phones 157
Comments on this document? infodev@avaya.com
To Next Page
Loading...
