Avaya J129 - Chapter 3: Getting Started; Entering the Provisioning Server Address; Logging in to Your Phone

Chapter 3: Getting started
Entering the provisioning server address
About this task
Use this procedure to enter the provisioning server address where asked to do so. For example,
when the phone is first plugged into the network.
Before you begin
Get the provisioning server address from the system administrator.
Procedure
1. On the Configure Provision Server screen, press one of the following softkeys:
• Config: To enter the provisioning server address.
• Never: To never prompt for the provisioning server address.
• Cancel: To cancel the prompt and display the Log Out screen. You can also press Back
to cancel the prompt and display the Log Out screen.
2. In the Prov Server field, enter the provisioning server address. The address can be in the
form of a numerical IP address or an alphanumeric Fully Qualified Domain Name (FQDN).
Tip:
To enter the dot symbol (.) in the field, press the alphanumeric softkey to toggle to the
alphanumeric mode.
3. Press Save.
The phone reboots.
Logging in to your phone
About this task
Before you begin
Get the log in password from the system administrator.
March 2017 Using Avaya J129 IP Phone 17
Comments on this document? infodev@avaya.com