Placing a call on hold or resuming the call
Procedure
1. Press Hold to put a call on hold.
The phone generates audio visual alerts after a fixed time interval as a reminder that the
phone is on hold. The time interval is set by the system administrator.
2. Press the following to resume the call:
• Resume
• OK
Conference calls overview
The phone supports the following audio conference types:
• Meet-me conference: You can manually enter the conference bridge number by using the dial
pad to join the audio conference.
• Ad-hoc conference: You must be on an active call to initiate an ad-hoc audio conference.
Adding a person to an active call
About this task
You can add participants to an active call to set up a conference call.
Before you begin
Start a call.
Procedure
1. During a call, on the Phone screen, press More > Conf.
The phone puts the existing call on hold.
2. To make a call to a participant, do one of the following:
• Dial the phone extension by using the dial pad.
• Call the person from the Contacts list or the Recents list.
3. When the third participant answers the call, press the Join soft key.
4. To add another person, press Add and repeat Steps 2 and 3.
Adding a person on hold to a conference call
About this task
Use this task to add a person that you have put on hold to a conference call.
Call operations
October 2019 Using Avaya J129 IP Phone in an Open SIP environment 26
Comments on this document? infodev@avaya.com
To Next Page
Loading...
