Avaya J129 - Identifying the device type during phone boot-up; Logging in to your phone

• Never: To never prompt for the provisioning server address.
• Cancel: To cancel the prompt and display the Login screen.
3. After you press Config, enter the provisioning server address in the Addr field.
The address is an alphanumeric URL. For example, http://myfileserver.com/
j100/.
Tip:
To enter the dot symbol (.) in the field, press the alphanumeric soft key to toggle to the
ABC mode.
To enter the forward-slash symbol (/) in the field, press the / soft key.
4. (Optional) Enter the Group number.
Obtain the Group number from your system administrator. The value ranges from 0 to 999.
If you do not enter a value, the phone uses the default value of 0.
5. Press Save.
The phone continues the boot process and connects to the provisioning server.
Identifying the device type during phone boot-up
About this task
Avaya J100 Series IP Phones screen displays the device type during the phone boot-up. This
feature is supported from the phone software version 4.0.3 and later.
Procedure
1. Set up the phone hardware.
2. Plug the Ethernet cable to the phone.
The phone powers up and starts to initialize.
The phone screen displays Starting... Avaya SIP.
Logging in to your phone
About this task
Perform this task to log in to your phone.
Before you begin
Get the log in password from the system administrator.
Identifying the device type during phone boot-up
October 2022 Using Avaya J129 SIP IP Phone in Avaya Aura
®
17
Comments on this document? infodev@avaya.com