Putting a conference call on hold and resuming a call
About this task
Use this procedure to put a conference participant on hold, while other participants continue the
conference call.
Procedure
1. Press Hold button during a conference call.
2. Do one of the following:
• Press Resume.
• Select the call appearance to resume the conference call.
No Hold Conference
With the No Hold Conference feature, you can add participants to your call while continuing your
active conversation. The No Hold Conference feature lets you create a conference call without
putting any call participant on hold.
For example, if you press the administered No Hold Conf button and then dial an extension the
participant that answers the call joins the no hold conference.
Using the No Hold Conf button you can add more participants to the no hold conference.
The administrator can pre-configure only one number on System Manager. When you press
the No Hold Conf button, the call is placed to the pre-configured number when the participant
answers the call joins the no hold conference.
If the participants do not answer the call within the configured time-out duration Avaya J100 Series
IP Phones will display the appropriate message on the phone screen.
Related links
Adding a participant to no hold conference on page 41
Adding a participant to no hold conference
About this task
You can add participants to your call while continuing your conversation without interruption. You
can add up to six participants in the no hold conference call.
Before you begin
Ensure that your administrator activates the no hold conference feature and feature target
selection.
Ensure that you are on a call.
Putting a conference call on hold and resuming a call
October 2022 Using Avaya J129 SIP IP Phone in Avaya Aura
®
41
Comments on this document? infodev@avaya.com
To Next Page
Loading...
