Avaya J159 - Identifying the Device Type During Phone Boot-Up; Logging in to Your Phone

• Never: To never prompt for the provisioning server address.
• Cancel: To cancel the prompt and display the Login screen.
3. After you have pressed Config, enter the provisioning server address in the Address field.
The address is an alphanumeric URL like http://myfileserver.com/j100/.
Tip:
To enter the dot symbol (.) in the field, press the alphanumeric soft key to toggle to the
ABC mode.
To enter the forward slash symbol (/) in the field, press the / soft key.
4. (Optional) Enter the Group number.
Obtain the Group number from your system administrator. The value ranges from 0 to 999.
0 is the default value. If you do not enter any value in this field, the phone uses the default
value.
5. Press Save.
The phone continues to boot and connect to the provisioning server address for
provisioning configuration.
Identifying the device type during phone boot-up
About this task
Avaya J100 Series IP Phones screen displays the device type during the phone boot-up. This
feature is supported only in the phone software version 4.0.3 and later.
Procedure
1. Set up the phone hardware.
2. Plug the Ethernet cable to the phone.
The phone powers up and starts to initialize.
The phone primary screen displays one of the following as the backsplash screen:
• A screen with Avaya text for Avaya SIP phones
• A screen with Open SIP text for Open SIP phones
Logging in to your phone
Before you begin
Your extension and password are provided by your administrator.
Identifying the device type during phone boot-up
April 2021 Using Avaya J159 SIP IP Phone in Avaya Aura
®
21
Comments on this document? infodev@avaya.com