Setting the network configuration
About this task
To set the network configuration to Auto or Manual. You do not need to perform this procedure if
your phone is configured to connect to Ethernet or a specific Wi-Fi network.
When network configuration is Auto, every time the phone restarts, it will connect to the pre-
configured network that your administrator has set up.
When network configuration is Manual, every time the phone restarts, it will connect to the network
that you manually configured by Setting the network mode on page 116 or Connecting to a Wi-Fi
network on page 118, irrespective of the pre-configured network that your administrator has set
up.
Note:
Any time you manually change the connected network, the phone will automatically set
Network config to Manual.
Procedure
1. Press Main menu.
2. Scroll to Settings, and press Select.
3. Scroll to Network, and press Select.
4. Scroll to Network config.
The Network configuration shows following two options:
• Auto: To automatically connect a network.
• Manual: To manually connect to a network.
5. Press one of the following:
• Toggle
• Right arrow key
• Left arrow key
6. Press one of the following:
• Save
• OK
Note:
If you do not want your phone to restart and stay in the Manual mode when you switch
Network config from Auto to Manual, press Save.
Setting the network mode
April 2020 Using Avaya J159 IP Phone SIP 117
Comments on this document? infodev@avaya.com
To Next Page
Loading...
