Visual Alerting
The message waiting lamp at the top-right corner of the phone can also be used to indicate when
you have a call alerting your phone. The lamp is flashed to indicate a call waiting to be answered.
Procedure
1.
Press the button.
2. Use the cursor keys to select Settings.
3. Use the cursor keys to select Phone.
4. Use the cursor keys to select Alerting on calls.
5. Use the cursor keys to select Beacon LED.
6. Press Toggle to change the setting.
7. When completed, press Save.
8. Press Back/Exit to exit the menus.
Related links
Ringer Controls on page 140
Coverage Ring
If you have any bridged appearance and or call coverage buttons, you can set the type of ringing
(coverage ring) that should be used when a call alerts on any of those buttons. The options are to
use normal ringing, a single non-repeated ring (abbreviated ring) or no ring. The coverage ring
setting is only used if you do not already have a connected call. If you already have a connected
call in progress, the shorter of the coverage ring and attention ring settings is used.
• This is a user setting which moves with you if you hot desk another phone.
• This menu is not supported on the J139.
Procedure
1. Press the Features soft key if shown.
• To do this during a call, press the
PHONE key and then press Features.
2. Use cursor keys to select Call Settings.
3. Use the cursor keys to select Coverage Ring.
4. Press the Change soft key to change the setting.
• Ring - Use normal ringing.
• Abbreviated - Use a single non-repeated ring (abbreviated ring).
• Off - No ring.
Visual Alerting
April 2020 J100 Series Phone User Guide 141
Comments on this document? infodev@avaya.com
To Next Page
Loading...
