• If applicable, Avaya Aura
®
Presence Services 6.2.4 or later
• If applicable, Avaya Aura
®
Session Border Controller 7.0 or later
• If applicable, IP Office IPO 11.0.0 or later
• A DHCP server for providing dynamic IP addresses to the Avaya J100 Series IP Phones.
• A file server, an HTTP, HTTPS, or the Avaya Aura
®
Utility Services for downloading the
software distribution package and the settings file
IPv6 deployment requires Avaya Aura
®
Session Manager v7.1 or later, Avaya Aura
®
Communication Manager v7.1 or later, Avaya Aura
®
System Manager v7.1 or later, and Avaya
Aura
®
Session Border Controller v7.1 or later. For more information about installing and
configuring the components, see their respective documentation.
Administration methods
You can use the following methods to administer the devices. The following table lists the
configuration parameters that you can administer through each of the corresponding methods.
Method Can administer
IP
addresses
Tagging
and VLAN
Network
Time
Server
Quality of
Service
Application-
specific
parameters
DHCP —
LLDP — — —
Settings file —
Avaya Aura
®
System Manager and IP
Office
— — — —
Administration menu on the phone — —
Web UI
Precedence of administration methods
Most of the parameters are configured through multiple methods. If you configure a parameter
through more than one method, the device applies the settings of the method that has a higher
precedence. The following list shows the precedence of the methods in the highest to lowest
order:
1. Administration menu on the phone. When the parameter USE_DHCP is set to 1, the phone
gets the DHCP values from the DHCP rather than Administration menu of the phone.
2. Administering the phone from the web UI.
3. Avaya Aura
®
System Manager and IP Office.
Initial setup and connectivity
July 2019 Installing and Administering Avaya J100 Series IP Phones 30
Comments on this document? infodev@avaya.com
To Next Page
Loading...
