Parameter name Default value Description
• Whether an IPv4 or IPv6
addresses returned by DNS
would be tried first during dual-
mode operation.
DHCP clients use DUAL_IPPREF
to decide which SSON
configuration attributes to apply
for DHCPv4/DHCPv6
interworking in dual mode.
Value operation:
• 4(Default): IPv4 is preferred.
• 6: IPv6 is preferred.
PRIVACY_SLAAC_MODE 1 Specifies the preference for
Privacy Extensions.
Value operation:
• 0: Disable Privacy Extensions.
• 1(Default): Enable Privacy
Extensions, and prefer public
addresses to temporary
addresses.
• 2: Enable Privacy Extensions,
and prefer temporary addresses
to public addresses.
IPV6STAT 1 Specifies the mode of the IP
family which will be used in the
current configuration.
Value operation:
• 0: Only IPv4 mode is enabled.
• 1(Default): Dual mode is
enabled.
• 2: Only IPv6 mode is enabled.
Configuring IPv6 from the phone menu
About this task
Use this procedure to configure IPv6 addresses from the phone Ethernet IPv6 menu. In this menu,
you can also view the phone IPv6 address, gateway address and prefixes if configured.
IPv4 and IPv6 overview
December 2018 Installing and Administering Avaya J100 Series IP Phones 125
Comments on this document? infodev@avaya.com
To Next Page
Loading...
