Turning error tones on and off
About this task
Use this procedure to activate the error tone alarm when you perform an incorrect action while
using the phone.
Procedure
1. Press Main menu.
2. Scroll to Settings, and press Select.
3. Scroll to Audio, and press Select.
4. Use the Down Arrow key to go to the Error Tones screen.
5. Press Toggle to turn error tones on or off.
6. Press Save.
Enabling wireless headset bidirectional signaling
Before you begin
Check if the headset supports electronic hook switch (EHS) signaling.
Note:
Headset Signaling setting is used to configure only DECT headsets and cannot be applied to
Bluetooth headsets.
Procedure
1. Press Main menu.
2. Scroll to Settings, and press Select.
3. Scroll to Audio, and press Select.
4. Scroll to Headset Signaling, and press Select.
5. Press Toggle to select one of the following options:
• Disabled: Disables signaling from the phone to the headset.
• Switchhook and Alert: Activates the link to the headset if you press Headset. When
the phone receives an incoming call, you hear the alert tone in the headset.
• Switchhook only: Activates the link to the headset if you press Headset. When the
phone receives an incoming call, you do not hear the alert tone in the headset.
6. Press Save.
Audio
October 2019 Using Avaya J169/J179 IP Phone in an Open SIP environment 103
Comments on this document? infodev@avaya.com
To Next Page
Loading...
