Chapter 6: Handling outgoing calls
Making a call by using the manual dial mode
About this task
In a manual dial mode, you can edit the dialed input and initiate a call using the current dialed
string. When you initiate a call, there is no dial tone, and no time out for completing the dialed
string.
• Do one of the following:
- Lift the handset.
- Press Speaker.
- Press Headset.
• Dial the number, and press the Call soft key or OK button.
Or
• Just dial the number, and press the Call soft key or OK button.
If your system administrator has enabled the digit mapping feature the phone can
automatically correct wrongly dialed numbers or prevent you from dialing certain numbers.
Related links
Setting the dialing mode on page 131
Basic call handling
Making a call by using the auto-dial mode
About this task
In an auto-dial mode, when you initiate a call by off-hook, you hear a dial tone until you press any
digit from the dial pad. You can edit a partially entered dialed input after initiating a call. You hear a
DTMF feedback tone for the digits pressed on the dial pad. The phone automatically places the
call when it detects that the dialing string is complete or when there is a time out.
To initiate a call quickly, you can press the # key to indicate the end of the dial, and the phone
places the call.
April 2021 Using Avaya J169 and J179 SIP IP Phones in Open SIP 37
Comments on this document? infodev@avaya.com
To Next Page
Loading...
