2 Installing Your System
24 Connecting Lines and Extensions
Quick Reference Guide
3 Route each cord through the wire manager on the front of the module.
4 Connect the free end of each line cord to the appropriate network interface
jack.
5 Test the lines by plugging a system telephone into extension jack 10. Press
the line button for each outside line and listen for a dial tone.
6 Test the extensions by doing the following:
• Plug a system telephone into the first extension jack on each module.
• Press the line button on the telephone for each outside line and listen for
a dial tone.
7 Connect modular telephone cords to the extension jacks, starting at the top
extension jack on the processor module. When that module is full, move to
the leftmost module. Fill each module before moving on to the next module
to the right. Note that extension 10 and extension 11 have system
administration privileges.
8 Route each cord through the wire manager on the front of the module.
9 Connect the free end of each modular telephone cord to the modular wall
jacks for system extensions.
10 Gather the line and extension cords hanging below the wire managers of
the first two modules, and twist-tie or wire-wrap them. Repeat for the
remaining cords. For the 5-slot carrier, place each bundle of wires in the
indentations cut out of the bottom edge of the carrier.
To Next Page
Loading...
