6 Maintaining Your System
66 Backup and Restore
Quick Reference Guide
Backup Programming—Manual (#124)
Use this feature to manually back up all the programming (except the system
date and time) to either the internal memory of the processor module or a
Backup/Restore PC Card.
To begin a manual backup of system settings:
1 If you want to back up to a PC Card, verify that only one Backup/Restore
Card is in the processor module.
2 Press f00ss#124 at extension
10 or 11.
The current setting appears.
3 To change the setting, press D or d until the setting you want
appears, or press
r to return to the factory setting. The possible
settings are:
• 1 = Internal Memory
•2 = PC Card
If there is a problem, a message appears (see Chapter 7, “If Something
Doesn’t Work” for explanations and corrective actions).
If there is no problem, press
e to begin the backup.
4 Press e.
A status message is displayed indicating that a backup is in progress, and
within 30 seconds, a message appears indicating the result.
If the backup failed, an error message appears (see Chapter 7, “If
Something Doesn’t Work,” for explanations and corrective actions).
• Backup Failed:Check Card
• Backup Failed:SystemBusy
• Backup Failed:Insert Valid Card
5 Exit programming mode.
To Next Page
Loading...
