PARTNER
®
Advanced Communications System Installation, Programming, and Use
Call Waiting (#316)
4-16
Call Waiting (#316) 4
Use this feature to activate Call Waiting. When you are on a call and a second intercom,
transferred, or outside call comes in, you hear two beeps to indicate you have a second call
waiting to be answered. Press the switchhook (or Recall or Flash button, if available) to put the
current call on hold and retrieve the second call. To return to the first call, press the switchhook
again.
Considerations 4
■ This feature is distinct from the local telephone company’s Call Waiting feature. If you use this
system feature, do not use your local telephone company’s Call Waiting feature.
■ The Call Waiting tone (two beeps) is not repeated.
■ Use Call Waiting only for single-line telephone extensions. Do not assign Call Waiting to
extensions that have fax machines, credit card scanners, modems, or auto attendants
because the call-waiting tone interrupts the data connection.
■ You cannot transfer either party connected by Call Waiting, conference in additional parties,
or use feature codes while both calls are active.
■ Transfer-return, group call distribution, hunt group, and wake-up calls are not considered
incoming calls for this feature.
■ For instructions on using Call Waiting, see “Answering Calls” on page 6-20.
■ Call Waiting does not apply to parked calls.
Programming 4
To change the Call Waiting setting for an extension:
1. Press
f00ss#316 at extension 10 or 11.
2. Enter the number of the extension to be programmed.
3. To assign or unassign Call Waiting, press
D until the appropriate value appears.
■ 1 = Assigned
■ 2 = Not Assigned (the factory setting)
4. To program another extension, press
n or p until the extension number appears
on the display. Then repeat step 3.
5. Select another procedure, or exit programming mode.
To Next Page
Loading...
