Avaya PARTNER Advanced Communications System - Page 151

Programming System Options
Pool Programming
4-53
Programming 4
To assign pools to a pooled extension:
1. Press
f00ss#314.
2. Enter the system extension number to be programmed.
There is a steady red light next to each button that has a line assigned and a flashing red light
next to each button that has a pool assigned. To remove all existing pool assignments, press
r before selecting a pool.
3. Enter the desired pool access code (880, 881, 882, or 883). For example, to select pool 881,
press 881.
4. Do one of the following:
■ If you want to assign the pool to the first available button with lights, press D until a
display similar to the following appears:
Pool Ext Assign 15 P881
1 Assigned
■ If you want to remove a pool assignment, press D until a display similar to the
following appears:
Pool Ext Assign 15 P881
2 Not Assigned
■ For auxiliary pools only, if you want to assign the pool to a specific button, press 3. A
display similar to the following appears:
Pool Ext Assign 15 P881
3 Select a Button
Then press a button with lights to assign the auxiliary pool to that button. If you use option
3 after an auxiliary pool has been assigned, the auxiliary pool moves from the old button to
the new button you select.
5. Do one of the following:
■ To assign another pool for this extension, press n or p until the pool access
code appears on the display. Then repeat Step 4.
■ To program another extension, press N + P and begin at Step 2.
6. Select another procedure, or exit programming mode.