Programming & Using Telephone Features
Recall (F03)
8-53
Programming 8
To program a Privacy button:
1. Press
f00.
2. Press a programmable button with lights.
3. Press
f07.
4. Program another button for this extension, or exit programming mode.
Using Privacy 8
From a system telephone, press the programmed button to turn Privacy on. Press it again to turn
it off. Use the button like a switch—when the light is on, Privacy is on.
Recall (F03) 8
Use this feature to send a timed switchhook flash over the telephone line to “recall” a new dial tone
or to access a PBX, central office, or Centrex feature, such as Call Waiting.
Considerations 8
■ Using Recall on an intercom call disconnects the call.
■ Using Recall while recording an intercom call disconnects the call.
■ Whenever your PBX or Centrex documentation tells you to press the switchhook when you are
on an outside call, use the Recall feature instead. If you are already on a call, most PBX or
Centrex systems require that you press the switchhook to get a new dial tone and then dial a
feature access code to access a specific PBX or Centrex service.
— On a system telephone, press a programmed button or press
f03 to use Recall.
— On a single-line telephone, first press and release the switchhook to get intercom dial
tone. Then send a Recall signal by pressing
#03.
— On a (single-line) feature telephone that has a Recall or Flash button, first press the
Recall or Flash button to get intercom dial tone. Then send a system Recall signal by
pressing
#03.
■ You can program a Recall button on a system telephone to send a Recall signal with one
touch.
■ Recall cannot be used with Call Screening (F25).
■ If users have trouble with Recall, use Recall Timer Duration to adjust the length of the Recall
signal. Your local telephone company can tell you the correct setting—for most Centrex
systems, the correct setting is 800 msec. (or 32).
To Next Page
Loading...
