Avaya PARTNER Advanced Communications System - Touch-Tone Enable (F08); Considerations; Programming; Using Touch-Tone Enable

PARTNER
®
Advanced Communications System Installation, Programming, and Use
Touch-Tone Enable (F08)
8-70
Touch-Tone Enable (F08) 8
Use this feature to send touch-tone signals on an outside call over a rotary line. For example, you
may need to dial touch-tone digits while on a call to a bank-by-telephone service. You can use
Touch-Tone Enable only from a system telephone.
Considerations 8
■ Touch-Tone Enable is needed only when dialing on a rotary line.
■ Use Touch-Tone Enable only after a call is connected. For example, use this feature after
dialing a bank-by-telephone service that requires you to dial touch-tone digits.
■ You can program a Touch-Tone Enable button on a system telephone to turn on Touch-Tone
Enable with one touch.
■ You cannot use Touch-Tone Enable with Call Screening (F25).
■ To activate this feature from within a number stored on an Auto Dial button or as part of a
Speed Dial number, press
& when storing the number.
Programming 8
To program a Touch-Tone Enable button:
1. Press
f00.
2. Press a programmable button.
3. Press
f08.
4. Program another button for this extension, or exit programming mode.
Using Touch-Tone Enable 8
From a system telephone, press the programmed button or press
f08 when you need to
enter touch-tone digits. Touch-Tone Enable stays in effect until you hang up.