Avaya PARTNER Advanced Communications System - Replacing Modules in a 5-Slot Carrier

PARTNER
®
Advanced Communications System Installation, Programming, and Use
Replacing Modules
10-14
8. Remove the screw at the top of the processor module, and remove the module from the wall
(see Figure 10-10).
Figure 10-10. Removing the Top Screw
9. Mount the new PARTNER ACS processor module by following the instructions in “Wall-
Mounting a Stand-Alone Processor Module and a 2-Slot Carrier” on page 2-5 and “Inserting
Batteries in the Processor Module” on page 2-11 earlier in this guide.
10. Mount or remount the top module by following the steps in “Wall-Mounting a Stand-Alone
Processor Module and a 2-Slot Carrier” on page 2-5.
11. Connect the line and extension cords one at a time, making sure to place the correct cords
into their corresponding jacks on the new module. (See “Connecting Lines and Extensions” on
page 2-16.)
12. Reconnect the power cord.
CAUTION:
The power cord should hang straight down from the connector, flush against the plastic
case. Do not install the power cord at an angle to the case or with a loop in it.
Replacing Modules in a 5-Slot Carrier 10
Replacing a module in a 5-slot carrier involves many of the steps used in installing the modules.
CAUTION:
Before starting, verify that you have batteries installed in the processor module by viewing
the display of the telephone at extension 10.
PAR
TNER
3000