Avaya PARTNER Advanced Communications System - Programming a PARTNER System

Overview
3-1
3
Initial System Programming 3
Overview 3
After you install the system hardware, you must program basic system settings, assign lines, and
customize extensions. To do this, you must understand the basics of programming.
Programming a PARTNER System 3
You can program a PARTNER system in either of the following ways:
■ from a PC running PARTNER ACS R6.0 PC Administration software (PC Administration)
■ from a system display telephone at extension 10 or extension 11 (Set Administration)
PC Administration 3
The PARTNER ACS R6.0 PC Administration software enables you to program and administer all
features for a PARTNER system from a local (that is, on-site) or remote PC. Using this application,
you can:
■ program features to the PARTNER system
■ set the date and time on the PARTNER system
■ copy buttons from one set to another
■ back up the programming (translations) from the PARTNER system to the PC card in the
PARTNER system
■ retrieve a copy of the translation from the PC card in the PARTNER system to your PC
■ print the system programming information to a text file
■ retrieve and view diagnostic information from the PARTNER system
■ administer the DSL module
■ administer the T1 module