Pre-upgrade service pack requirements
Issue 2 June 2005 15
On the LSP’s primary controller
20. Verify LSP status.
● At the SAT prompt, enter display lsp.
The LSP name and IP address should be
listed. The Service State? field should be
in-service/idle.
● The Translations Updated should match
the translations date and time on the
primary controller. To view the primary
controller’s translations date and time,
enter list configuration software.
21. If the LSP’s
translations have not
synchronized with the
primary controller,
invoke translation
synchronization.
● On the primary controller, enter the Linux
command filesync -a ipaddress
where ipaddress is the IP address of the
LSP.
● Ensure that the translation synchronization
completed successfully. Wait several
minutes, then check the timestamp of the
LSP translation files using the SAT
command display lsp on the primary
controller.
Post-upgrade tasks
22. Implement any
additional design
changes to voice and/
or voice messaging
networks.
23. Re-register the
S8300B as an LSP
with the Avaya remote
servicing center.
Task Steps/Comments
To Next Page
Loading...
