Issue 2 June 2005 61
At the customer site
Perform the tasks in this section at the customer site.
Task Steps/Comments
Go to the standard documentation
Use Installation and Upgrades for Avaya G700 Media Gateway and Avaya S8300 Media
Server, 555-234-100, Issue 8, April 2005.
To convert the G350 LSP to a G700 LSP, you complete selected tasks from Chapters 2 and 3.
You need to complete only some of the tasks in these chapters. The specific tasks are
identified by page number in the left-hand column. The subtasks to perform or skip are listed in
the right-hand column.
It is important to note where the task is performed. Most of the tasks are done on a server or
gateway — on the LSP S8300B, on the primary controller for the LSP, on a DHCP server, or on
the G700 media gateway processor (MGP). The headings in the table indicate on which of
these devices the task is performed.
On the G350 LSP
1. Backup all system files —
translations, OS, and
security backup sets.
Start on page 229.
These backup sets will be restored on the G700 LSP.
2. Record configuration
information
Page 232.
If you have not already done so, in the Record
Configuration Information task, record all of the
configuration information, regardless of the fact that you
are not upgrading Communication Manager.
You will re-enter some of this information after the
conversion.
3. Install the G700 media
gateway hardware.
Page 86.
Unpack, check, and mount the G700 in a rack.
4. Shut down the S8300B in
the G350.
Note: The final disposition of the G350 Media
Gateway is beyond the scope of this
procedure.
5. Remove the S8300B
Media Server.
Place in a safe, static-free place.
To Next Page
Loading...
