Avaya S8300 - Page 70

Upgrading Communication Manager from 2.x to 3.0 on an S8300 Media Server
70 Converting an Avaya S8300 Media Server Between ICC and LSP Modes
6. Save Translation.
Page 303.
7. Upgrade the S8300B,
using the Web
Interface, Manage
Software screens.
Starting on page 303,
ending on page 316.
● Copy files from the Server CD/
● Install files on the S8300B.
● Make upgrade permanent.
8. Install post-upgrade
service pack, if any
Page 317.
9. Set time, date, and
time zone.
Page 246.
The time zone of the S8300B must be set.
ICC mode: All LSPs under the S8300B ICC’s
control must be set to the ICC’s time zone.
LSP mode: The time zone of the S8300B must
be set to the time zone of the primary controller.
10. Install post-upgrade
service pack file, if any.
Page 247.
Skip the Verify Media Server Configuration
section starting on page 247.
11. Verify that the media
gateway has
registered with either
the primary controller
(LSP mode) or the
S8300B (ICC mode).
● Open a SAT session with either the
primary controller (LSP mode) or the
S8300B (ICC mode) and enter list
media-gateway.
Verify that the Registered field (Reg?) is set
to y.
● Place a test call.
ICC mode: On LSPs of the S8300B (if any)
12. Reboot LSPs (if any) At the LSP’s SAT prompt, enter reset system
4.
13. Verify LSP translations
date and time (if any).
To view the LSP’s translations date and time,
enter list configuration software.
Task Steps/Comments