Avaya S8300 - Page 72

Upgrading Communication Manager from 2.x to 3.0 on an S8300 Media Server
72 Converting an Avaya S8300 Media Server Between ICC and LSP Modes
17. If the S8300B LSP’s
translations have not
synchronized with the
primary controller,
invoke translation
synchronization.
● On the primary controller, enter the Linux
command filesync -a trans.
● Ensure that the translation synchronization
completed successfully.
Wait several minutes, then check the
timestamp of the LSP’s translation files
using the SAT command display lsp on
the primary controller.
18. Upgrade the G700
Media Gateway
firmware.
Start on page 318.
Using the Avaya Installation Wizard on the
S8300B Web Interface to upgrade the gateway
firmware is recommended.
● Upgrade G700 firmware
● Upgrade media module firmware
19. Set Rapid Spanning
Tree
Page 322.
20. Install post-upgrade
IA770 service pack, if
any.
Page 323.
Post-upgrade tasks
21. Implement any
additional design
changes to voice and/
or voice messaging
networks.
22. Re-register the
S8300B (LSP mode
only) with the Avaya
servicing center.
Task Steps/Comments