Avaya S8500 Series - Removing and Replacing the SAMP Card in the S8500 C Server

Replacing the SAMP on the Avaya S8500C server
03-300529 Issue 4 January 2008 101
To remove the cover from the S8500C server:
1. Press the release button on the top, left side of the server (see Figure 21: Release button
on the S8500C server on page 101).
Figure 21: Release button on the S8500C server
2. Slide the server cover back from the front panel until the cover’s tabs are released from the
top slot of the front panel.
3. Lift the cover straight up and set it aside.
Removing and replacing the SAMP card in the S8500C server
The SAMP card resides in PCI-X slot 1 located under the PCI support bracket. To remove the
PCI support bracket and the riser connector in the S8500C server:
1. Loosen the captive screw on the SAMP riser-card assembly as shown in Figure 22
.
Figure notes:
1. Cover release button 2. Push cover back and lift straight up.
C
D
-R
W
DVD
1
h3msc85c LAO 032306
2