Avaya S8500 Series - Page 102

Job Aid: Replacing the SAMP on the Avaya S8500 Series server
102 Job Aids for Field Replacements (FRUs) for the Avaya S8500 Server
Figure 22: Removing/replacing the SAMP card on the S8500C server
!
CAUTION:
CAUTION: In the next step, do not pull too hard because the cable assembly is attached to
the SAMP card.
2. Disconnect the cable assembly from the SAMP and from the motherboard (see
Figure 22: Removing/replacing the SAMP card on the S8500C server
on page 102).
3. Remove the riser-card assembly by holding the narrow (interior) part of the assembly with
one hand and the other hand under the support bracket near the captive screw and pulling
straight up (see Figure 22: Removing/replacing the SAMP card on the S8500C server
on
page 102).
Figure notes:
1. Remove cable assembly from SAMP
2. Remove riser-card assembly
3. Remove SAMP from riser-card
assembly
2
1
Slot 1
Slot 2
2
3
h3mss85c LAO 032306
1
3