Job Aid: Replacing the Avaya S8500/B/C server
50 Job Aids for Field Replacements (FRUs) for the Avaya S8500 Server
!
CAUTION:
CAUTION: Wear an antistatic wrist ground strap whenever handling the server or its
components. Connect the strap to an approved ground, such as an unpainted
metal surface. See the job aid titled Approved Grounds for more information.
Removing the NIC from the failed S8500B server
To remove the network interface card (NIC) from the failed S8500B server:
1. Carefully grasp the new NIC by the top edge or upper corners and pull up, unseating the
card from the PCI-2 expansion slot. See Figure 10
.
Figure 10: Removing/replacing the NIC from/in the replacement S8500B server
Installing the NIC in the replacement S8500B server
To re-install the dual NIC card into the replacement S8500B server:
1. Align the dual NIC card with the PCI-2 expansion slot on the motherboard.
Note:
Note: The SAMP board is connected on the other side of the PCI-2 expansion slot
connector.
2. Press the NIC firmly into the expansion slot.
2
1
indsbnic KLC 101404
To Next Page
Loading...
