Final tasks
03-300529 Issue 4 January 2008 81
5 Set a timeout value
RSA: On the RSA welcome screen, in the Inactive
session timeout value field, select no timeout and
click Continue. This allows 60 minutes of use before
disconnecting.
SAMP: At the home page select Controls. Select boot
protection timer. Select a value of 0. Click on set
control. Logout of the SAMP.
6 Set the loader watchdog
timeout
Under ASM Control, click System Settings. Scroll down to
the Server Timeouts section, and in the Loader watchdog
field, select disabled and click Save.
7 Log off the RSA/SAMP Click Log Off.
8 Remove the RSA/SAMP LAN
cable
Disconnect the Ethernet RJ45 cable from the RSA/SAMP
Ethernet port.
9 Connect laptop to the server Connect a crossover cable to the services port on the back
of the server and wait about 3 minutes from the time you
boot up the server before trying to access the information on
the CD.
10 Clear ARP cache on laptop From a DOS command link, type arp -d 192.11.13.6
and press Enter.
11 Set display parameters (if
necessary)
At the Linux command line type unset crlf and press
Enter.
Type display and press Enter to verify that message says
Sending only CR
Type exit and press Enter to close the session.
12 Install Communication
Manager
You must install the software from the CD. For procedure
details, see Installing Communication Manager
on page 92.
13 Log onto the Maintenance
Web Interface
Open a browser on your laptop. Type 192.11.13.6 and
press Enter to log onto the Maintenance Web Interface.
Note: Use the initial installation login craft and the initial
password.
14 Set alarm suppression on the
server
At the Linux command prompt screen, type almsuppress
-y and press Enter to enable alarm suppression.
15 Check software version Under Server, click Software Version to verify that the hard
drive has the current release of Communication Manager.
16 Copy files to the server Copy the license and Avaya authentication files and the
software service pack file, if any, to the server.
On the Maintenance Web Interface, under Miscellaneous,
click Download Files.
Browse to select the file for downloading and click
Download.
Final tasks for replacing a hard drive in an S8500 server (continued)
9 Task Description
2 of 5
To Next Page
Loading...
