Avaya S8500 Series - Page 83

Final tasks
03-300529 Issue 4 January 2008 83
23 Install the license and Avaya
authentication files
Under Security, click License File and select “Install the
license I previously downloaded” and click Submit.
Under Security, click Avaya Authentication and click
Install.
24 Copy translations Using a SAT screen, type reset system 4 and press
Enter to initialize Communication Manager with the restored
translations.
25 Log in from the SAT Log in as craft.
26 Check the translations Using the SAT screen, type list configuration all
and press Enter and check that all the hardware is
displayed.
27 Ping the connections on the
server
Under Diagnostics, click Ping. Ensure that all connections,
IPSI boards, and all administered connections respond.
28 Resolve alarms on the server Under Alarms, click Current Alarms. Compare these
against the recorded alarms from Checklist 2, step 4. Clear
any alarms that appear.
To resolve alarms, using a SAT screen, type display
alarms and press Enter.
29 Check the health of the server Using a SAT screen, type list ipserver-interface
and status health. Check that all connections are
working correctly.
30 Save translations Using a SAT screen, type save translation and press
Enter to save the current translation.
31 Administer backup schedule
on the server
On the Maintenance Web Interface, under Data Backup/
Restore, click Schedule Backup to re-administer the
server’s backup schedule.
32 Set the Product ID on the
server
At the Linux command line type productid -p
product_id and press Enter, where product_id is the
product ID you received from the customer or the ART tool.
It should be the same product ID as the old hard drive.
33 Back up files on the server Under Data Backup/Restore, click Backup Now.
Click Start Backup to begin the back up process.
34 Release alarm suppression on
the server
At the Linux command line type almsuppress -n and
press Enter to release alarm suppression.
Note: Only do this if you want to release it before the time
you set earlier runs out (maximum of 2 hours)
35 Log off all administration
applications
When you have completed all the administration, log off the
server.
36 Disconnect the RJ45 cable Disconnect the Ethernet RJ45 crossover cable from the
Services port on the server.
Final tasks for replacing a hard drive in an S8500 server (continued)
9 Task Description
4 of 5