Avaya S8500 Series - Replacing the Hard Drive in the S8500 B Server

Replacing the hard drive in the S8500 server
03-300529 Issue 4 January 2008 87
Replacing the hard drive in the S8500B server
This procedure contains the following sections:
l Removing the hard drive from the S8500B server
l Installing the replacement drive on the S8500B server
Removing the hard drive from the S8500B server
To remove the hard drive from the S8500B server:
1. Turn off the server and peripheral devices.
2. Label and disconnect all external cables.
3. Remove the server from the rack.
4. Press the release tabs on the bezel and pull the bezel away from the server (see Figure 18
).
Figure 18: Removing/installing the hard drive in the S8500B server
5. Pull the hard drive from the server.
6. To remove the hard drive from the drive tray, unscrew the four screws and remove the hard
drive.
disc
indsbhdv KLC 101404