Postmigration administration
Migrating to the Avaya S8700 or S8710 Media Server 107
June 2004
Postmigration administration
This section covers the following tasks:
• Assigning IP addresses to the IPSI circuit packs on page 107
• Verifying IPSI translations on page 112
• Verifying IPSI connectivity on page 113
• Enabling control of IPSI(s) on page 113
• Verifying customer’s data on page 115
• Upgrading firmware (if necessary) on page 115
• Testing the installation on page 116
• Busying out trunks on page 116
• Troubleshooting the migration on page 116
• Returning replaced equipment on page 116
Assigning IP addresses to the IPSI circuit
packs
IP server interface circuit packs get IP addresses in one of two ways:
• Using dynamic host configuration protocol (DHCP)
• Using static IP addressing
The IPSI circuit packs associated with a dedicated control network use the DHCP method. In rare cases
they might use the static addressing method.
The IPSI circuit packs associated with a nondedicated control network use the static addressing method.
In rare cases they might use the DHCP addressing method.
Using DHCP addressing
For the TN2312BP IPSI circuit packs to get IP addresses dynamically, you must first assign the switch ID
(A through J) and the cabinet number (01 through 64) to each IPSI circuit pack. For G650 Media
Gateways, a cabinet is defined as one or more media gateways connected by TDM cable, which is called
a G650-rack-mount-stack.
Administering the location assignment
1 Fully insert the TN2312BP IPSI circuit pack. If necessary, reseat the circuit pack to begin the
programming sequence.
NOTE:
You must do the following steps within 5 seconds after inserting the circuit pack.
To Next Page
Loading...
