Postmigration administration
Migrating to the Avaya S8700 or S8710 Media Server 109
June 2004
3 All segments of the display goes dark for one second, and then the Switch ID and media gateway
stack number is displayed in the top three characters of the LED display. A "V" is shown in the
fourth character (bottom) of the display. When the DHCP server assigns an address to the IPSI,
the center of the "V" is filled in to form the bottom half of a diamond in the display.
For duplicated control network, repeat these steps for the second IPSI in the cabinet.
Using static addressing
For the IPSI circuit packs to get static IP addresses, you must administer them directly through the
Ethernet port connection on the IPSI faceplate (top port). See Figure 21, Connecting directly to the IPSI,
on page 110.
CLK
S
E
R
V
fpdlled2 LJK 022502
To Next Page
Loading...
