Avaya S8500 - On the S8500 Media Server; Access the Media Server; Disconnect the Cables; Shut down the Media Server

2 Migrating from an S8500 Media Server to S8710 Media Server
On the S8500 Media Server
134 Migrating to the Avaya S8700 or S8710 Media Server
June 2004
On the S8500 Media Server
Access the media server
1 Clear the ARP cache on the laptop if necessary. (See Clear the ARP cache on the laptop on page
122 and return here.)
2 Connect to the services port on the standby media server.
3 Log in and launch the Web browser. (See Access the media server on page 123 and return here.)
Shut down the media server
CAUTION:
Do not unplug a functioning server without stopping all processes first. Failure to do this
corrupts the hard drive.
1 Under Server, click Shutdown Server then
• deselect Restart Server after Shutdown.
• select Delayed shutdown
• select Shut down even if this is the active server.
2 Click Shutdown.
CAUTION:
Do not hold down the power button for more than a split second. Holding the button down
too long causes the media server to reboot.
3 Press the power-control button on the front of the server. The internal fan shuts off.
Disconnect the cables
1 Disconnect the laptop from the services port.
2 Disconnect the power cord from the UPS.
3 Disconnect the power cord from the RSA.
4 Disconnect the modem from the RS-232 port on the RSA.
5 Disconnect the LAN connection (if used) from the Ethernet port on the RSA.
6 Disconnect and label the cable from the Ethernet port on the dual NIC (if used).