Accessing the media server
102 Installing and Configuring the Avaya S8700 Series Media Server
Network configuration
Note:
Note: Write down the original settings in case you need to change them back.
A new network connection must be configured as follows:
Note:
Note: These instructions are for Windows 2000/XP only.
1. On your computer desktop, right-click My Network Places and left-click Properties to
display the Network Connections window.
Windows 2000/XP should have automatically detected the Ethernet card in your system
and created a LAN connection for you. More than one connection may appear.
2. Right-click on the correct Local Area Connection and left-click Properties to display the
Local Area Connection Properties dialog box.
3. Select Internet Protocol (TCP/IP).
4. Click Properties to display the Internet Protocol (TCP/IP) Properties dialog box.
5. On the General tab, select Use the following IP address. Enter the following:
● IP address: 192.11.13.5
● Subnet mask: 255.255.255.252
Make a note of any IP addresses or other entries that you have to clear. You may need to
restore them later to connect to another network.
6. Select Use the following DNS server addresses. The entries for Preferred DNS server
and Alternate DNS server should both be blank.
7. Click Advanced at the bottom of the dialog box to display the Advanced TCP/IP Settings
dialog box.
8. Click the DNS tab. Make sure no DNS server is administered (the address field should be
blank).
9. Click OK, OK, and Close to close all the windows.
To Next Page
Loading...
