Migration tasks
Issue 2.1 June 2006 485
The following list describes general procedures:
● Turn off the power to the processor gracefully - pre-conversion administration
● Replace the processor control carrier/cabinet with an expansion control carrier or cabinet
● Replace the tone clock circuit pack and Maintenance circuit pack with an IP Server
Interface (IPSI) circuit pack and new maintenance circuit pack, respectively
● Replace old expansion interface circuit packs with new expansion circuit packs, if
necessary
● Connect the IPSI circuit pack to the Ethernet switch on the customer network
● Assign an IP address to the IPSI circuit pack
Perform the following tasks to convert a processor port network to a port network (SCC).
Premigration administration:
● Connecting to the processor on page 487
● Verifying system status on page 487
● Recording all busyouts on page 487
● Recording node names and IP addresses on page 488
● Saving translations on page 488
Migration tasks:
● Accessing the media server maintenance web interface on page 489
● Verifying the license file on page 489
● Copying translation files to media server on page 489
● Restoring translation files on page 490
● Administering the IPSIs on page 490
● Adding IPSI translations to Communication Manager on page 491
● Setting the alarm activation level on page 491
● Backing up translations on page 492
● Verifying hardware on page 492
● Removing the processor port network control cabinet on page 493
● Installing the expansion control carrier on page 493
● Stacking the port media gateways on page 494
● Installing IPSI and maintenance circuit packs on page 494
● Connecting the CAT5 cables to the IPSI circuit packs on page 497
● Installing Expansion Interface circuit packs on page 501
To Next Page
Loading...
