Maintenance-Object Repair Procedures
555-233-143
8-836 Issue 1 May 2002
Expansion Interface Neighbor Query Test (#237)
This test is nondestructive. The Expansion Interface Neighbor Query test is a
request to an EI circuit pack to determine whether it has established
communication with the EI or SNI circuit pack at the opposite end of the fiber.
For EI-to-EI fiber links, this test is run on both EI circuit pack endpoints of the fiber
link.
Table 8-324. Test #237 Expansion Interface Neighbor Query Test
Error
Code
Tes t
Result Description / Recommendation
1033 ABORT The EI circuit pack does not have a fiber link administered to it. There is not
sufficient data to run test. Since the test fiber-link command was run, the
expansion interface should be administered on a fiber link, therefore this must
be a software problem.
2000 ABORT Response to the test request was not received within the allowable time period.
1. Run the test board UUCSS test separately for each EI endpoint on this
fiber link and follow the procedures for this test in ‘‘EXP-INTF (Expansion
Interface Circuit Pack)’’.
2031 ABORT The attempt to send the message to the EI circuit pack, asking it who it’s
neighbor is, was not successful.
1. Run the test board UUCSS test separately for each EI endpoint on this
fiber link and follow the procedures for this test in ‘‘EXP-INTF (Expansion
Interface Circuit Pack)’’.
2100 ABORT System resources required to run this test are not available.
1. Run the test board UUCSS test separately for each EI endpoint on this
fiber link and follow the procedures in ‘‘EXP-INTF (Expansion Interface
Circuit Pack)’’.
2500 ABORT Internal system error
1. Run the test board UUCSS test separately for each EI endpoint on this
fiber link and follow the procedures in ‘‘EXP-INTF (Expansion Interface
Circuit Pack)’’.
1033 FAIL The EI circuit pack under test cannot make contact with opposite end EI or SNI
circuit pack.
1. Run the test board UUCSS test separately for each EI endpoint on this
fiber link and follow the procedures in ‘‘EXP-INTF (Expansion Interface
Circuit Pack)’’.
2027 FAIL The EI circuit pack has contact with the opposite EI or SNI circuit pack, but it is
the incorrect EI or SNI circuit pack.
1. Run the test board UUCSS test separately for each EI endpoint on this
fiber link and follow the procedures in ‘‘EXP-INTF (Expansion Interface
Circuit Pack)’’.
Continued on next page
To Next Page
Loading...
