Avaya S8700 - Verify IPSI Firmware Version; Enable Control of Ipsis; Verify License Status; Connect the USB Modems

109
Connecting the Hardware
October 2002
Verify IPSI firmware version
1 Under Installation and Upgrades click View IPSI Version. Select Query All and click
View IPSI Version.
2 Verify the firmware release for each TN2312AP IPSI. If an upgrade is required, select
the Upgrading tab above and go to Upgrading IPSI Firmware.
Enable control of IPSIs
1 Type change system-parameters ipserver-interface and press Enter.
2 Make sure the IPSI Control of Port Networks: field is set to enabled.
3 Press Enter to effect the changes.
Verify License Status
The following administration is done on a computer used to access the active media server
using the media server Web interface.
1 Under Security click View License Status and verify that the license mode is now
normal.
Connect the USB Modems
!
WARNING:
Once the modems are cabled to the servers, do not unplug the modem USB cable on the
active server. If modems must be changed, do it on the standby server.
Required options in the modems will be set by the operating system on the server. There are no
options to set on the modems themselves.
Co-located servers
Both servers share one telephone line.
change system-parameters ipserver-interface Page 1 of 1
IP SERVER INTERFACE (IPSI) SYSTEM PARAMETERS
SERVER INFORMATION
IPSI Host Name Prefix:
Primary Control Subnet Address: 172. 22. 0. 0
Secondary Control Subnet Address: . . .
OPTIONS
Switch Identifier: A
IPSI Control of Port Networks: enabled