• From the XT Series web interface, select select Store on the row of the new position
number.
Figure 87: Storing a camera preset
4. To save your choice on the endpoint, press ok/menu.
The position number of the preset turns blue, indicating it was successfully stored.
On the web interface, the Assigned column now contains a check mark.
5. To delete a previously stored position with the XT Remote Control Unit, press its number
and then press the Delete key.
From the web interface, select Delete on the row of the position number.
Setting the Default Camera Position
About this task
You can make any of your preset positions the default position. Each time the system reboots, the
XT Remote Control Unit selects the default camera and positions the camera to the specified
preset.
Before you begin
Before you assign a camera position as the default, you must save a camera position, as
described in
Saving PTZ Camera Positions on page 187.
Setting the Default Camera Position
August 2020 Deployment Guide for Avaya XT Series 189
Comments on this document? infodev@avaya.com
To Next Page
Loading...
