Avaya XT Series - Upgrading the Software Using a Web Browser

3. Follow the instructions displayed on the screen.
The system restarts automatically after the upgrade procedure is completed.
4. The upgrade procedure may automatically continue after the reboot, and therefore reboot
again. Wait a few minutes to ensure that the upgrade procedure is completed.
5. If the upgrade fails, see
USB software upgrade failure on page 280.
Upgrading the Software Using a Web Browser
About this task
You can log in to your Avaya Room System XT Series using a web browser to update the
firmware.
Before you begin
Check if a later version is available by accessing the Avaya site as explained in
Updating the XT
Series on page 201. If a later version is available, download it and save it to your computer.
Procedure
1. Save the upgrade package to your computer.
2. Open a web browser and log in to the XT Codec Unit by browsing to the XT Codec Unit IP
address.
The default credentials are:
• Username: Admin
• Password: 1234
3. From the XT Series web interface, select Administrator Settings > Utilities > Software
Update and click Next.
4. Browse for the file (.exe) that you saved locally on your computer and upload it to the web
browser.
5. Click Upload-Install.
Caution:
Do not shut down the XT Series until the upgrade has completed.
The XT Series uploads the file and then begins the installation process. A progress bar
displays the progress. When the installation is complete, the web client may disconnect.
6. Wait for the automatic reconnection or press F5.
You might need to login again.
Advanced Configuration of the XT Series
August 2020 Deployment Guide for Avaya XT Series 206
Comments on this document? infodev@avaya.com