Connecting the PTZ Camera
About this task
This procedure describes how to connect the main PTZ camera to the Avaya Room System XT
Series. The XT7000 and XT5000 use the XT Premium Camera or the Avaya XT Series Deluxe
Camera. The XT4300 uses the XT Flex Camera.
Figure 24: Flex Camera
Figure 25: Deluxe Camera
For details about the camera's capabilities, see Technical Specifications on page 20. For more
information about the room setup, see Planning the Optimal Room Setup on page 52.
Procedure
1. Place the camera in a position to ensure eye contact between local and remote
participants.
If the XT Codec Unit is housed in a cabinet, the XT Remote Control Unit sends the signal
to the infra-red receiver of the main camera to relay messages to the XT Codec Unit. In
this case, configure the camera settings so the camera's power is always on (see
Configuring Cameras on page 126).
Try positioning the camera between the two monitors either directly above or below them,
at a distance which captures all the seats.
Caution:
Do not place the camera on top of the XT Codec Unit. It can cause the system to
overheat.
Setting Up the XT Series Hardware
August 2020 Deployment Guide for Avaya XT Series 60
Comments on this document? infodev@avaya.com
To Next Page
Loading...
