Avaya XT Series - Installing Avaya Room System XT Control to Use Keyboard and Mouse (Avaya XTE240)

Field Description
Authentication Password If necessary, enter the password for authenticating your Avaya XT
Series with the SIP server.
Use SIP Server Enable registering the system to the SIP server by selecting Yes.
For redundant SIP deployments, you can enter information for up
to three SIP servers, as described in Deployment Guide for Avaya
XT Series.
Server Address Enter the DNS name or IP address of the SIP server, used to
register the endpoint.
2. Select Done to complete the Quick Setup Wizard.
3. To configure advanced SIP settings, such as the preferred transport protocol, see
Deployment Guide for Avaya XT Series.
Related links
Configuring Basic Settings with the Quick Setup Wizard on page 27
Installing Avaya Room System XT Control to Use Keyboard and Mouse
(Avaya XTE240)
About this task
This procedure describes how to configure your Avaya XTE240 (only) to navigate its menus with a
keyboard and mouse by installing Avaya Room System XT Control, a small standalone program
for Windows or Mac (see
Navigating Menus with the Keyboard and Mouse on page 47).
Note:
You cannot install the Avaya Room System XT Control installation package on a Mac that is
running the Yosemite operating system. The Yosemite operating system does not allow you to
install packages obtained from outside of the Apple Store. However, there is a workaround
available to enable you to obtain and run the installation package if you have the Yosemite
operating system (or a higher operating system, such as El Capitan or Sierra). For more
information, see
Resolving download problems on page 125.
The Avaya Room System XT Control utility can only be installed from the endpoint's web interface.
Before you begin
1. Verify your computer is running either Windows XP/Vista/7/8, or if it is a Mac, verify it is
running OSX 10.x or higher.
2. Connect your computer to the Avaya XTE240 (see
Connecting a Computer to the Avaya
XT Series using the DVI port on page 77).
3. Perform the Quick Setup wizard, which ends with the Avaya Room System XT Control
installation, or install it at any time from the web interface.
Procedure
1. The Quick Setup wizard provides the web address to access your endpoint from the web,
and displays a user code to pair a computer's keyboard and mouse to the endpoint. You
enter this code at the end of the installation, so make a note of it now.
Setting up Avaya XT
March 2021 User Guide for Avaya XT Series 32
Comments on this document? infodev@avaya.com